Product Description
UJK Parf Chamfer Tool
Enables full use of the Parf Super Dog, plus helps protect your 20mm worktop holes
This specially designed chamfer cutter tool cuts a neat, small chamfer around a precise 20mm dog hole. You can also use it on the Festool MFT/3 table or any custom worktop made using the UJK Technology Parf Guide System. A shallow chamfer has two benefits: it allows full use of the UJK Parf Super Dog when fitted with its stop collar; and secondly, by removing the sharp edge around the hole, it prevents damage from repeated insertion of dogs, clamps and other accessories—not to mention the occasional painful finger snag!
The UJK parf chamfer tool has a solid tungsten carbide cutter with four cutting edges. If the edge becomes dull, simply turn the cutter 90° to a fresh edge. In all probability, it will never need replacing. This hand chamfer tool is only suitable for use with MDF/HDF.
- Designed to cut a small chamfer around a 20mm dog hole
- Suitable for use on the Festool MFT/3 table and others
- Cutting a chamfer enables use of Parf Super Dog and its stop collar, and also helps protect your 20mm worktop holes
- Solid tungsten carbide cutter with 4 cutting edges
NOTE: Designed and intended for use on MDF and HDF material. NOT recommended for hardwood veneer plywood.
Got a suggestion to make this page even better? Your feedback and suggestions are always welcome!
Other Details
Non-TSO brand products are covered by the warranty of their respective manufacturer.Product Videos
Custom Field
Product Reviews
26 Reviews Hide Reviews Show Reviews
-
UJK Chamfer tool
This added a nice finishing touch to the 100 or so dog holes I made in 2 rolling carts.
-
Great tool
Works perfectly and easy to use.
-
UJK Chamfer Tool
Difficult to use (old hands). It would be better if it could be used with a drill
-
Chamfer tool
Works as it should as long as you don't press down too hard. Let the tool do the work.
-
Nice product
Nice product
-
UJK chamfer tool
The tool works quite well but is rather tiring to use if you are doing more than 10 or 12 holes. I drilled and tapped a hole in the top center for a 1/4” bolt so I could use a battery drill with nut driver bit turn the tool. That made it much quicker and easier to operate. I would give it the top rating if UJK made it that way to start with.
-
UJK Chamfer tool
Well made but it was way easier for me to use a chamfer bit on my hand router. I had to use it on plywood and the blade stuck and grabbed. If I used it on MDF, I think it would have been much easier to use.
-
It works
I bought it but figured it would get tiring to use when I made my mft top. I was wrong. Its actually faster than using a chamfer bit on my router.
-
UJK chamfer tool
Work as advertised, compliments the parf dog. Defintoa must for a perfect fit dogs
We are continually striving to improve our products based on customer input. While we make every attempt to keep our product pages up-to-date, know that the product you receive may reflect recent improvements and therefore differ slightly from the product depicted. We reserve the right to change specification of products without notice.