UJK Parf Chamfer Tool
Enables full use of the Parf Super Dog, plus helps protect your 20mm worktop holes
This specially designed chamfer cutter tool cuts a neat, small chamfer around a precise 20mm dog hole. You can also use it on the Festool MFT/3 table or any custom worktop made using the UJK Technology Parf Guide System. A shallow chamfer has two benefits: it allows full use of the UJK Parf Super Dog when fitted with its stop collar; and secondly, by removing the sharp edge around the hole, it prevents damage from repeated insertion of dogs, clamps and other accessories—not to mention the occasional painful finger snag!
The UJK parf chamfer tool has a solid tungsten carbide cutter with four cutting edges. If the edge becomes dull, simply turn the cutter 90° to a fresh edge. In all probability, it will never need replacing. This hand chamfer tool is only suitable for use with MDF/HDF.
- Designed to cut a small chamfer around a 20mm dog hole
- Suitable for use on the Festool MFT/3 table and others
- Cutting a chamfer enables use of Parf Super Dog and its stop collar, and also helps protect your 20mm worktop holes
- Solid tungsten carbide cutter with 4 cutting edges
NOTE: Designed and intended for use on MDF and HDF material. NOT recommended for hardwood veneer plywood.
Got a suggestion to make this page even better? Your feedback and suggestions are always welcome!
Warranty & Returns
This added a nice finishing touch to the 100 or so dog holes I made in 2 rolling carts.
Works perfectly and easy to use.
Difficult to use (old hands). It would be better if it could be used with a drill
Works as it should as long as you don't press down too hard. Let the tool do the work.