Description
Make Your MFT More Useful with this Hand Chamfer Tool
This specially designed chamfer cutter tool cuts a neat, small chamfer around a precise 20mm dog hole. You can use it on the Festool MFT/3 table or any custom worktop made using the Parf Guide System. A shallow chamfer has two benefits: it allows full use of a wide variety of tools—from TDS-13 Dog Stops, to Chamfer Dogs, to the UJK Parf Super Dog—plus, it removes the sharp edge around the hole to prevent damage from repeated insertion/removal of dogs, clamps, and other accessories... Not to mention the occasion painful finger snag!
This hand chamfer tool has a solid tungsten carbide cutter with four cutting edges. If the edge becomes dull, simply turn the cutter 90° to a fresh edge. In all probability, it will never need replacing.
Note: This hand chamfer tool is only suitable for use with MDF/HDF. For hardwood veneered plywood, we recommend a 45° chamfer router bit with pilot bearing.
- Designed to cut a small chamfer around a 20mm dog hole
- Suitable for use on the Festool MFT/3 table and others
- Cutting a chamfer enables use of a wide variety of tools such as the TDS-13, Chamfer Dogs, and Parf Super Dogs
- Helps protect your 20mm worktop holes and prevent finger snags
- Solid tungsten carbide cutter with four cutting edges
Warranty & Returns
32 Reviews
-
Chamfer tool
This tool works perfectly. It is solid and well finished and makes a nice consistent chamfer. My only critisim is that I feel it should have an option for a spindle drive. All it would take is to have a through hole in the center to accomodated a some kind of simple drive spindle like a headless bolt. If you have a large table full of holes it takes a while and is tiresome to twist ever hole by hand. Anyway, a good tool that could be better with a small design change.
-
Very good
Works great
-
Chamfer tool worked great on my MDF MFT table
This did a great job to finish my home made MFT table. I used MDF for its stabiliy. The chamfer this made was perfect. I only wish it had a 1/4" socket in the top so I could spin it with my drill. After 144 holes were chamfered, my wrist was a little tired.
-
UJK TECHNOLOGY CHAMFER TOOL
l like products that are well made! This is a very well made product! thanks for building Quality at UJK TECHNOLOGY
-
Easy to use
I like it easy to use