UJK Anti-Slip Workbench Protection Dogs
Keep your worktop pristine and productive
These anti-slip pads come in packs of eight and sit on 20mm dogs with a newly extended depth to help keep them securely in place. In use, they raise a workpiece slightly, enabling you to use a guide rail and plunge saw to cut through a workpiece while avoiding scoring the top of your multifunction workbench. These anti-slip dogs fit into any 20mm chamfered dog hole and allow work such as sanding to proceed without mechanical clamping, giving full access to a workpiece’s entire surface. Workholding is by friction alone.
- Avoid scoring the top of a workbench or MFT when sawing
- High friction anti-slip pads help keep work in place
- For multifunction and MFT workbenches with 20mm chamfered dog holes
Got a suggestion to make this page even better? Your feedback and suggestions are always welcome!
Other DetailsNon-TSO brand products are covered by the warranty of their respective manufacturer.
12 Reviews Hide Reviews Show Reviews
These anti-slip dogs have completely changed the way I sand. I no longer use those "anti-slip" mats which end up sliding all over the place. These will not move because they are securely fit into the dogs holes of my workbench. Because they do not move, the piece I am sanding also will not move. They also come in a really cool container to store them in when not in use. If you have dog holes, you need these. If you do not have dog holes, my God, add dog holes and buy these!
Great product very low profile which do not take up much room when stored. These small fogs really grip the workpiece for work such as sanding and planing.
UJK products are excellent but I found that these dogs are a bit too shallow in the dog hole and can flip out too easily.
These grip well and are the perfect height, however if you move the board, some of them slip out of the chamfer which raises them up. If you use them to protect your MFT from kerfs, any board position adjustments you make will dislodge the dogs. Too bad the dogs aren't deeper, with the same above-surface height, to hold them in place better.
The picture is misleading as it shows 8 x dogs. You only get 4 dogs. The product description should be updated to note the number of protection dogs in set. In addition, the dogs show a Red plastic like material on top. The dogs I received had a aluminum surface.
The dogs are not long enough to stay in the holes. Any movement of your workpiece across them pops them from their holes and then you have to spend time fussing with them to get them back into the holes. Benchdogs makes a version them is longer and do not get dislodged as easily.
Need to be 1/4" high off the bench.
They look very good, but I have not used them yet.
Like all UJK products, these are high-quality and work great. Just keep in mind that for proper support, your stock needs to cover two rows of dogs in each direction. so you'll still have to use different support for smaller stock.
We are continually striving to improve our products based on customer input. While we make every attempt to keep our product pages up-to-date, know that the product you receive may reflect recent improvements and therefore differ slightly from the product depicted. We reserve the right to change specification of products without notice.