UJK Parf Chamfer Tool
Enables full use of the Parf Super Dog, plus helps protect your 20mm worktop holes
This specially designed chamfer cutter tool cuts a neat, small chamfer around a precise 20mm dog hole. You can also use it on the Festool MFT/3 table or any custom worktop made using the UJK Technology Parf Guide System. A shallow chamfer has two benefits: it allows full use of the UJK Parf Super Dog when fitted with its stop collar; and secondly, by removing the sharp edge around the hole, it prevents damage from repeated insertion of dogs, clamps and other accessories—not to mention the occasional painful finger snag!
The UJK parf chamfer tool has a solid tungsten carbide cutter with four cutting edges. If the edge becomes dull, simply turn the cutter 90° to a fresh edge. In all probability, it will never need replacing. This hand chamfer tool is only suitable for use with MDF/HDF.
- Designed to cut a small chamfer around a 20mm dog hole
- Suitable for use on the Festool MFT/3 table and others
- Cutting a chamfer enables use of Parf Super Dog and its stop collar, and also helps protect your 20mm worktop holes
- Solid tungsten carbide cutter with 4 cutting edges
NOTE: Designed and intended for use on MDF and HDF material. NOT recommended for hardwood veneer plywood.
Got a suggestion to make this page even better? Your feedback and suggestions are always welcome!
Other DetailsNon-TSO brand products are covered by the warranty of their respective manufacturer.
26 Reviews Hide Reviews Show Reviews
This tool works perfectly. It is solid and well finished and makes a nice consistent chamfer. My only critisim is that I feel it should have an option for a spindle drive. All it would take is to have a through hole in the center to accomodated a some kind of simple drive spindle like a headless bolt. If you have a large table full of holes it takes a while and is tiresome to twist ever hole by hand. Anyway, a good tool that could be better with a small design change.
This did a great job to finish my home made MFT table. I used MDF for its stabiliy. The chamfer this made was perfect. I only wish it had a 1/4" socket in the top so I could spin it with my drill. After 144 holes were chamfered, my wrist was a little tired.
l like products that are well made! This is a very well made product! thanks for building Quality at UJK TECHNOLOGY
I like it easy to use
I purchased the Champer Tool along with the Parf guide system mark 2 Very happy with both. This tool gives my DIY TOPS a nice finished look. And allows you to use the Parf Super Dogs.
The chamfer tool works great (5-stars) on MDF and Plywood; however, if you use Melamine for a work surface, then there will be chipout of the Melamine - hence 4 stars.
If you order the parf super dogs the chamfer tool is a must
This tool works perfectly to quickly chamfer the MFTs and my shop made table tops with the 20mm holes. The tool has some weight to it and the scoring on the handle makes it have a good gripping surface. Well made and I would buy it again.
We are continually striving to improve our products based on customer input. While we make every attempt to keep our product pages up-to-date, know that the product you receive may reflect recent improvements and therefore differ slightly from the product depicted. We reserve the right to change specification of products without notice.