UJK Technology Parf Chamfer Tool
Enables full use of the Parf Super Dog, plus helps protect your 20mm worktop holes
This specially designed tool cuts a neat, small chamfer around a precise 20mm dog hole. You can also use it on the Festool MFT/3 table or any custom worktop made using the UJK Technology Parf Guide System. A shallow chamfer has two benefits: it allows full use of the Parf Super Dog when fitted with its stop collar; and secondly, by removing the sharp edge around the hole, it prevents damage from repeated insertion of dogs, clamps and other accessories—not to mention the occasional painful finger snag!
The parf chamfer tool has a solid tungsten carbide cutter with four cutting edges. If the edge becomes dull, simply turn the cutter 90° to a fresh edge. In all probability, it will never need replacing. Only suitable for use with MDF/HDF.
- Designed to cut a small chamfer around a 20mm dog hole
- Suitable for use on the Festool MFT/3 table and others
- Cutting a chamfer enables use of Parf Super Dog and its stop collar, and also helps protect your 20mm worktop holes
- Solid tungsten carbide cutter with 4 cutting edges
NOTE: Designed and intended for use on MDF and HDF material. NOT recommended for hardwood veneer plywood.
Got a suggestion to make this page even better? Your feedback and suggestions are always welcome!
At TSO Products, we are continually striving to improve our products based on customer input. While we make every attempt to keep our product pages up to date, know that the product you receive could reflect recent improvements and therefore differ slightly from the product depicted. We reserve the right to change specification of products without notice. Standard equipment and specifications may differ from country to country.
9 Reviews Hide Reviews Show Reviews
This tool works perfectly to quickly chamfer the MFTs and my shop made table tops with the 20mm holes. The tool has some weight to it and the scoring on the handle makes it have a good gripping surface. Well made and I would buy it again.
Great tool and well made. Tolerances are very tight and works quickly. Will last a lifetime and beyond
Hi Guys I will be short. I purchased the Parf Mark II guide system along with 3 super dogs, 2 rail clips and the.chanfer tool.
This entire system Rocks....!
5 stars for everything purchased.
I also have my sites on the TSP Rail Square.
I will be set.
Should have purchased the rail saw and guide system years ago.
Thanks Guys for a Great Product.
Extremely well made and simple to use. A possible improvement could be to add an adaptor allowing for use in a variable speed drill as in my case I have over 200 holes to chamfer so will have to complete in stages as my wrist wouldn’t handle that level of manual twisting. I highly recommend this product as it is built to last a life time.
Very disappointed in the tearout left by this tool in every hole. Used this tool in 20mm holes drilled into cabinet grade maple plywood (A1) and simply made a mess of the benchtop. Purchased and tried to correct with a drill mounted chamfering tool from Amazon. Cleaned things up a lot but still have quite a bit of visible tearout. This tool is probably ok for MDF but I wouldn't use it on anything else. Given the quality, precision and expense of the other UJK tools, one would think that attention to the chamfering tool would be warranted.
Works great however would like something I could use in drill pretty exhaustive for large top.
Works very well even in birch plywood
While I'm building my own MFT-style assembly bench, I decided I wanted to simplify work holding. So I drilled some 20mm dog holes (using the Parf Guide System) in a hard maple cabinetmaker's bench. I then used the chamfer tool to cut a chamfer. It certainly worked. A few turns, and I had a chamfer. I deducted a star because I got some tearout in the hard maple. This will probably not happen in plywood or mdf, but it's definitely there in hard maple.