Watch this video to see the features and refinements of the TPG FlipStop v2.0.
This kit contains everything you need to upgrade your original TPG FlipStop to Version 2.0. This upgrade can be completed in less than five minutes. The TPG FlipStop has always been reversible, so it doesn't matter if your FlipStop is configured for left-hand or right-hand T-tracks. Once upgraded, you will get all the benefits of a TPG FlipStop v2.0, including Calibration Memory™ and the internal spring loading feature that keeps the stop planted securely in the T-track.
What's Included in the Box
- 1 qty. TPG FlipStop v2.0 Upgrade Kit
A Closer Look at TPG FlipStop v2.0: Important Refinements
Material stops are often an afterthought—but why? They’re the part of the system you interact with the most, and critical at setting and maintaining accurate cuts. See what sets the TPG FlipStop v2.0 apart in the video below:
Got a suggestion to make this page even better? Your feedback and suggestions are always welcome!
Other DetailsTSO brand products are guaranteed for five years from date of sale against defects in materials or workmanship. Normal wear and tear and accidental damage are not covered. For any product determined to have a defect covered by this warranty, TSO Products will repair or, at its option, replace with current comparable product. Warranty requests require an RMA (return authorization number) prior to any return. Request an RMA number by contacting TSO Customer Service (firstname.lastname@example.org).
Videos Hide Videos Show Videos
4 Reviews Hide Reviews Show Reviews
Definitely make things easier to set and reset. The large blue bit is needed to create a recess for the spring. These are definitely easier to set, before I was doing a sort of three finger shuffle holding it down to the t-track, but now I can set it and tighten the knob without expecting it to move.
The advantages of the upgrade are minimal but well worth it if you use the parallel guide system very much. The added spring adds great stability and smoothness to setting the stop and the longer pin and memory ring is a time saver.
I dont understand TSO at this point and about 350$ in. They don't have any updated instructions, yet the packaging tell your to check out there website. Basically what you are getting is a screw and a stop collar. And only 1 set for the small rods. I had to order some from amazon for the large rods. There are ZERO instructions or videos on "upgrading". Save your money, I see no difference between the original "blue Aluminum track block" and the new one.
I value the usefulness of my parallel guide system, but I sometimes had a challenge getting the flipstop to stay where I wanted it because I did the tightened the screw. The upgrade is wonderful and I purchased a second set of V2.0 flipstops for multiple cuts of different lengths.
We are continually striving to improve our products based on customer input. While we make every attempt to keep our product pages up-to-date, know that the product you receive may reflect recent improvements and therefore differ slightly from the product depicted. We reserve the right to change specification of products without notice.